Try onlinemetals.com
73. Jeff
W3KL
Sent from my iPhone
> On Dec 28, 2019, at 12:34 PM, K9MA <k9ma@sdellington.us> wrote:
>
> Bob,
>
> Are you putting the rotator in the tower with a thrust bearing or sleeve?
>
> 73,
> Scott K9MA
>
>> On 12/28/2019 10:39, Dave Hachadorian wrote:
>> I bought a 10-footer once from Texas Towers. They cut 1 foot off to make it
>> UPS shippable. That was a long time ago though.
>>
>> Dave Hachadorian, K6LL
>> Yuma, AZ
>>
>>
>> -----Original Message----- From: Rob Matherly
>> Sent: Saturday, December 28, 2019 9:26 AM
>> To: TowerTalk@contesting.com
>> Subject: [TowerTalk] Masting source
>>
>> Hi All -
>>
>> Could someone point me to a source for antenna mast? It needs to be strong
>> enough for my A4S and 10-element 2m beam. I was thinking 10' in height, is
>> that too much? I've not had an actual bell rotor atop a tower before.
>> Everything prior has been TV rotors on masts.
>>
>> Thanks!
>>
>> Rob Matherly, W0JRM
>> Centerville, Iowa - EN30nr
>> SKCC 29, FISTS 19246
>>
>> "Aude, vide, tace, si vis vivere in pace."
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> --
> Scott K9MA
>
> k9ma@sdellington.us
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|