Towertalk
[Top] [All Lists]

Re: [TowerTalk] 80 meter antenna advice. (NY6DX)

To: Jim Thomson <jim.thom@telus.net>
Subject: Re: [TowerTalk] 80 meter antenna advice. (NY6DX)
From: electric911inc@hotmail.com
Date: Sun, 16 Feb 2020 12:18:18 -0500
List-post: <mailto:towertalk@contesting.com>
I think I am going to use both antenna systems and see what works best. Thanks 
all

Sent from my iPhone

> On Feb 16, 2020, at 11:16 AM, Jim Thomson <jim.thom@telus.net> wrote:
> 
> Date: Fri, 14 Feb 2020 13:23:30 -0600
> From: john@kk9a.com
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] 80 meter antenna advice. (NY6DX)
> 
> 
> <That's funny Jeff:)  In reality an 80m beam can be built strong enough  
> <to survive the midwest. I had a homebrew linear loaded dipole with a  
> <90+ ft element 160' high that held up well in Chicago. However if you  
> <want to operate both CW and SSB, you will need relays on the elements  
> <which can be problematic and difficult to maintain.
> 
> <John KK9A
> 
> ##  Heres  where  loaded  elements would  be a  huge  asset...to  minimize 
> max ele length ....  which  can  be  made  
> stronger....vs a  full  sized  ele.   T  bars,  aka  capacity  hats would be 
> a good  loading  scheme.  That  plus
> loading  coils,  just  inboard  of  T bars.   The  remaining  loading, and  
> ability  to  switch  from  cw  to  ssb
> can  be  done  with  fixed  coils  and a mess  of  relays....  or a seco  
> systems  tornado  drive..which is  just
> a  pair  of  compressible,  plastic  coated, .25 inch od   copper  tubing  
> coils.  The  seco  uses  an  ameritron  SDC-102  screwdriver
> controller,  12  vdc,  to  expand and  compress  the  coils.  Comes  with a  
> digital  readout turns  counter..and  10  x pre-sets.
> Tornado  drive  installed  at feedpoint  of  each  ele. 
> 
> ##  If  relays  are  used,  use  gigavac  SPDT  G2  type ceramic  vac  
> relays,  or  Taylor  brand V2  SPDT  ceramic vac  relays...  available
> in 12 vdc  or  26.5 vdc.    If  mech  relays  have  to  be used,  use DPST  
> types,  with  contacts  in  parallel......  for  redundancy. 
> 
> Jim   VE7RF  
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>