Check Grainger, maybe DX Engineering. 73,Gary K9GS
-------- Original message --------From: Gary <gary_mayfield@hotmail.com> Date:
5/31/20 4:29 PM (GMT-06:00) To: "'towertalk@contesting.com'"
<towertalk@contesting.com> Subject: [TowerTalk] Alliance HD-73 Rotator U-Bolt
Greetings, Last summer someone in the club decided tighter is
better and mangled the threads on the U-Bolt that is part of the mast clamp on
the club's Alliance HD-73 rotator. It is Alliance part number X-19434-B.An
email to Norm's got a message back saying they will only sell the whole clamp
assembly.A trip to several hardware stores has not turned up anything that
fits.I am not a machinist, but my measurements say the holes it goes through
are at most ¼ inch in diameter. They are 3 inches apart center to center.I
would love to find something the same original shape, but I think a standard
U-Bolt shape should work.Anyone know where to get something that works?Thanks
and 73,Gary "Joe"
kk0sd______________________________________________________________________________________________TowerTalk
mailing
listTowerTalk@contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|