Check McMaster-Carr online catalog
N9AU
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Don
Sent: Tuesday, July 21, 2020 10:27 PM
To: Towertalk <towertalk@contesting.com>
Subject: [TowerTalk] Flat Wrenches
And metric.
Don W7WLL
On 7/21/2020 2:03 PM, K9MA wrote:
Speaking of which, it's hard to find wrenches thin enough to lock two
6-32 or 8-32 nuts together. I have one old, cheap, Craftsman set that works,
but sooner or later I'm going to lose one of those up on the tower. All the
small wrench sets ("Ignition Wrenches") available seem to be too thick.
Short of grinding them down, does anyone know where to get thin ones in SAE
sizes?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|