Anecdotally, I made the mistake while I was posted in Laos in 1969 -
1971, of turning my SB220 on its side to trouble shoot a problem. I soon
discovered that wasn't a good idea. I noticed something wrong very
quickly and shut it off, fortunately before damage to the filament
transformer windings. Both tubes were damaged by the sagging filament
syndrome. It's one thing to be offshore and quite another to be in
CONUS. No internet, e-mail, just snail mail, or Amateur Radio. APO
Services were there, but took lots of time.
I fired up my spare SB-200 and was back on the air. Several of the US
Hams offered to send me the tubes, but in the end I got them from Henry
Radio. I didn't know about the caveat of running the 3-500 tubes while
on their sides. When the replacement tubes arrived, and were installed,
the SB-220 fired up and worked. I got lucky. The bias circuit survived
despite my best efforts to destroy it. It was pure luck that I didn't
repeat the same mistake. I still didn't know that operating the tubes on
their sides was a no-no. As I recall, there was nothing in the Heathkit
Manual that mentioned this. Perhaps Eimac had a bulletin, but being out
of the US made some resources unavailable.
That complete station followed me to the Ivory Coast and operated
without further problems. Great old amplifier, and remarkably, still is
in many stations!
73
Chuck, W6AJW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|