I would suggest not insulating the tower and, either shunt feeding it or
use slopers. You will have a problem with an insulated tower with feed
lines bridging the gap between the tower and ground.
Chuck W5PR
On Mon, May 31, 2021 at 1:44 PM Jessy Blanchette <ve4jbb@gmail.com> wrote:
> Hello Talkians!
>
> I am starting the foundation/ground work for a modest Rohn 45G tower
> (60'). To make extra use as a radiator I was planning to insulate the
> concrete base from the bottom section(pier bin base) with something flat
> and high compressive strength (1/2" HDPE, UHMW or even fiberglass sheet).
> A small insulated ring would also be needed around the pier pin to
> prevent it from direct contact as well.
>
> Tried searching the archives but I couldn't find an answer :( -- I believe
> this has been done in similar fashion with 25 towers with a tilt base plate
> and concrete anchors.
>
> Appreciate any comments, ideas or experience with this (or even telling me
> I am completely out to lunch)
>
> Thanks :)
>
> Jessy VE4JBB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|