Emery cloth or 600 grit sand paper.
Jim W7RY
On 2/18/2023 2:54 PM, Gedas wrote:
I was wondering if anyone had a simple method for removing the tarnish
off stranded #14 copper wire that has had the THNN insulation removed
in several areas? I will need to solder to these areas and the tarnish
will not allow normal 60/40 Rosin core to flow.
I am hoping for some home "remedy" or simple mixture that does not
involve some complex chemicals or procedures that can be applied on,
brushed then rinsed off. TU 73
Gedas, W8BYA EN70JT
Gallery at http://w8bya.com
Light travels faster than sound....
This is why some people appear bright until you hear them speak.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
Thanks and 73, Jim W7RY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|