Dear friends,
I built a W5XD+ Keyer, but it doesn't work.
I hope that no IC is broken, but that it is only a setup problem.
My serial cables are ok and checked.
I use 2 Icom 765 on com1 and com2.
I tried to setup w5xd+ keyer on com1 but nothing works. WL doesn't read the
frequency from the radio and does not set the radio on desired frequency. If
I use my usual logger software, through the w5xd keyer it reads the
frequency and sets the radio.
I also have no cw output.
How must I setup baud rate (usually 1200 with Icom), poll, Comm PTT and All
mode PTT on CW port RTS?
I have WL10.22b
Thanks
Gino Zambaiti IK2RZP
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|