Jim, I believe that you must have your PK-232 at 9600 baud.
PK-232 INTERFACING
A PK-232 may be used for CW keying. See the documentation of that device
for information on connecting the PK-232 to your computer. If WriteLog will
not communicate with your PK-232, it may be necessary to do the
editing described below.
Using NotePad edit C:\Windows\writelog.ini as follows:
In the file, go to the section labeled [Ports].
Look at the line for the Com port you intend to use. It will look like
this:
COM1:=9600,n,8,1,x
Check to be sure all parameters are correct, then Delete the final x (but
not
the comma). It should look like this:
COM1:=9600,n,8,1,
Click on File, Save. Then open WriteLog; this should allow
your PK-232 to communicate with WriteLog.
This works for RTTY also in Writelog.
I have other PK-232 info's at http://www.qsl.net/k0bx
Good Luck
Joe K0BX
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|