John,
At risk of getting in trouble twice in one day -
A band decoder and antenna relay works nicely. The FT1000mp puts out band
data. The W5XD keyer puts out band data. Writelog puts band data on a
parallel port with Win95/98.
My setup switches antennas by band automatically. And as long as you have
the Tuner button on it does tune; some times not as quickly as one might
want if you are hopping all around.
Jerry, W6IHG
At 09:42 AM 11/28/2001 -0500, John E Bastin, K8AJS wrote:
>I sent a note to the list about this problem once before and got no
>response, and I was aggravated with it again in CQ WW DX over the weekend,
>so I'll ask again.
>
>I've found that when changing bands in WL from a packet spot, for
>instance, that ONLY the frequency of the radio is changed. In my setup, I
>have the radio switch antennas when I go from 20 meters and above to 30
>meters and below, or vice versa. If I make a change like that using
>WriteLog, the antenna is not switched, and I find myself transmitting on
>the wrong antenna.
>
>ALSO, when I travel from the bottom of the band up some distance when
>going from spot to spot, the automatic antenna tuner doesn't pickup on the
>frequency change either, resulting in a higher SWR than I would have if I
>was tuning up the band using the tuning knob.
>
>Is there any solution for this problem, or is it a limitation in the CAT
>capabilities? Or worse yet, some problem with the 1000MP memory storage
>that it doesn't store antenna by frequency, for instance, but by what
>button on the front panel is pushed?
>
>Does anyone have any idea of a solution? It's a bit of a pain to remember
>to push the front panel button on the radio to switch bands before I go to
>a particular packet spot on that band.
>
>73,
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
------------------------------------------
Dr. Jerry R. Pixton, PIXOS Designs LLC
http://www.pixos.com/designs/RadioTuner/
jpixton@shentel.net
------------------------------------------
|