Jim,
You may be having a problem with the UART on the serial card working with
5 bit Baudot codes. I believe the ST-8000 uses the Dumb Terminal
selection in Writelog. Many of the newer PCI and some ISA cards do not
support 5 bits.
To verify it, set the ST-8000 up on com1 or 2 and rig on com 3. It should
work that way. Most computer comports still support 5 bits.
I have been working with another Ham trying to get the PCI-400 Byterunner
board to work in Dumb Terminal mode but no success. The UART does support
5 bits but the board does not .
73's
Don AF4Z
At 08:03 AM 01/03/2002 -0800, you wrote:
>I have tried unsuccessfully to use an Equinox 4 port serial card with
>Writelog. (6 serial ports total). The program will just not recognize them.
>I know the ports are working because I can use them with ProComm + for
>Windows on the same machine.
>
>What's the deal with Writelog and the difficulty with serial ports ?
>
>All I need is 3 serial ports...1-Rig 2-TNC for packet 3-RTTY TU. (Hal
>ST-8000)
>
>Thanks and 73!
>Jim W7RY
>
>
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
|