Hello Phil,
Nice to see you in WriteLog Gang :-)
> Number one is that if I click on QWE it won't "see" it as 123 for a serial
> number. Is this the way it works, or is there something I need to do? When
I
> tried it, it simply moved the cursor point to the next field.
You should press SHIFT key and click on this QWE or OYR. In this case WL
logs the correct number.
> Number two concerns the "check call" window, which I had hoped was going
to
> be very useful, but I found that it didn't "check" anything until the QSO
> was logged. Again, is this correct? Or is it just that way for WPX?
Phil, it works. When you put new callsign you see in CHECK CALL window
"OK" - it informs you, that this country (prefix in WPX was worked). If it
is new prefix it do not show "OK", just only bands. WriteLog does not show
all callsign you worked for this country (multiplier), but if you see "OK"
you know it has been worked. If you put callsgn of the station you worked
other band you see your QSO number, his callsign and received serial number.
I hope it helps.
Best 73's
Pawel, SP7PS
SN7N in contest
3Z0WPX this year (Multi Two station)
----- Original Message -----
From: "Phil Cooper" <pcooper@guernsey.net>
To: "Writelog" <writelog@contesting.com>
Sent: Monday, February 11, 2002 6:14 PM
Subject: [WriteLog] A couple of queries after WPX
> Hi all,
>
> Well, as this was only the second time I used WL, I found that it worked
> very well, and I enjoyed all the features I could fit onto my two
monitors.
>
> I do have a couple of queries though, and one of you kind gents may well
> have an answer.
>
> Number one is that if I click on QWE it won't "see" it as 123 for a serial
> number. Is this the way it works, or is there something I need to do? When
I
> tried it, it simply moved the cursor point to the next field.
>
> Number two concerns the "check call" window, which I had hoped was going
to
> be very useful, but I found that it didn't "check" anything until the QSO
> was logged. Again, is this correct? Or is it just that way for WPX? I was
> hoping that it would show which bands/calls I had worked already for that
> mult/call.
>
> Lastly, I thought I saw someone mention that the frequency displayed by
the
> Ctrl-T (to bring up the packet spot window) was displaying something other
> than that shown on the rig.
> Well, for the most part, mine showed what it should have done, EXCEPT for
a
> couple of occasions when it showed a frequency about 1kHz HIGHER that I
> actually was. Not sure about more than that, as I wasn't really paying too
> much attention to that particular area.
>
> 73 for now
> Phil GU0SUP
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
|