Randy
It has a long time since I had a 940 on the desk..
FSK RTTY has a separate jack (RCA), CW has a separate jack (1/4 mono, but all
other connections, audio out/audio in and PTT is done via the 13 pin DIN plug,
ACC1 or ACC2.
If you want to use AFSK RTTY, you can use the front mic jack.
FYI. The rear jacks can use your narrow filters.
More information can be found at;
http://www.packetradio.com/
Hope this helps
Tom KA2D
----- Original Message -----
From: "The Lakes" <rlake@webryders.net>
To: <WriteLog@contesting.com>
Sent: Friday, February 15, 2002 10:39 AM
Subject: [WriteLog] Need help with Kenwood TS940 hookup
> Gm all...I am new to Writelog and have everything in place except connecting
> the radio to the sound card.. I used to use a Hal rtty decoder but would
> like to try MMTTY. I hv a SB PCI128 a Kenwood TS940 with a Heil Proset and a
> computer interface for the rig. I hv looked thru the archives and the
> websites but am still unclear as to what to do. The TS 940 has a RTTY jack
> on the back and Rx audio I believe goes from the external speaker jack to
> the line in on the sound card. Where does the Heil plug in and how do I deal
> with RTTY and PSK31....CW works just fine (W1WEF interface)
> Anybody out there familiar with the 940 ?
> Thanks
> Randy N1KWF
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
|