> I've tried every thing I know of to get it to stay at the selected freq.,
> but no luck. Does this mean everyone that's using the Profile buttons in
the
> plug-in is using 2125 Hz mark freq.?
Not at all, Don. As a result of running RTTY from OE2-land for several
years, I also prefer to monitor 1275/1445 tones in FSK with the plug-in
MMTTY module. So very much easier on the ears.
Configurations for Profiles are each set up using the Option>Setup dialog,
then going to Profiles > Assign Menu and choose the appropriate profile
you're re-configuring. From then on, that Profile will reflect all the
changes you made. All Profiles you plan to use will need to be re-done to
change to low tones.
I also like to use the MMTTY engine with YPLOG and HamScope, so I've copied
my MMTTY.INI and UserPara.INI files into those directories. Profiles then
work the same with those programs as in stand-alone . It just takes more
nitty-gritty work to configure the Profiles for WriteLog, as the plug-in
doesn't use the usual INI files.
73,
Jon K1US
----- Original Message -----
From: "Donald Eriksen" <don.wsixffh@verizon.net>
To: <writelog@contesting.com>
Sent: Sunday, March 24, 2002 1:39 AM
Subject: [WriteLog] MMTTY Plug in Profile Problem
> I hate to turn this into a MMTTY reflector, but I've got a problem with
the
> Plug-in use with WL (not WL problem).
>
> I like to use a mark freq. of 1275 Hz rather than the MMTTY default of
2125,
> it's easier on my ears in the rig monitor.
>
> When I run the full-up MMTTY program, I can set the mark to any of the
> freq's listed in the "Option Demodulator setup pull-down menu and even
> modify the "HAM default" and it will retain the settings for each profile.
>
> But, when I run WL with MMTTY and click on any of the Profiles, the
received
> passband goes zinging off to the left of the spectrum (and waterfall )
> display. Sure enough, when I check the Demodulator setup, the mark has
been
> re-set to 2125.
>
> I've tried every thing I know of to get it to stay at the selected freq.,
> but no luck. Does this mean everyone that's using the Profile buttons in
the
> plug-in is using 2125 Hz mark freq.?
>
> Thanks in advance,
> Don W6FFH
> don.wsixffh@verizon.net
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
>
|