Please tell us where you found the UX-14PX? I've been looking for
these for years. I had been told they were no longer available from
Icom.
I'd be happy to help with this if I could get a UX-14PX. I have
two IC-751A's which I believe is one of the best FSK radios ever
made.
73, Don AA5AU
----- Original Message -----
From: "Katsuyuki ISHII" <kkii@hcc1.bai.ne.jp>
To: <writelog@contesting.com>
Sent: Sunday, June 16, 2002 4:55 PM
Subject: [WriteLog] Writelog and IC751A
> Hi, All:
>
> Recently I bought a UX-14PX, a level converter for IC751A and installed.
> When I run PC-DOS and CT on my notebook PC, my UX-14PX works well.
>
> I run Win2k and Writelog on my console PC, open Port Setup window and
> set up as follows:
>
> Rig: COM1, Rig type: Icom IC-751, Baud: 9600. Poll: checked, Comm PTT: No
>
> Then I save this configuration, close Writelog and run again.
>
> The frequency counter beside Entry Window changes as VFO of IC751A does.
> But, I cannot change the band by alt+f1 and alt+f2 and the frequency
> by entering from Entry Window.
>
> I manipulated DIP SW on UX-14PX, replaced the hex address of IC751A with
> that of IC781, IC761 etc and tried again, but failed.
>
> Any help and suggestions will be appreciated.
>
> Thanks in advence.
>
> ----
> Katsuyuki Ishii kkii@hcc1.bai.ne.jp
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
|