Sounds like you have some format inconsistencies between the ADIF file and
the WL contest you are importing to.
Try entering a QSO or two into WL and export it to ADIF and compare that
file with the ADIF file you need to import. You may need to change a few
things in the ADIF file to make it work like the name of some of the fields.
The red B means the QSO is considered out of band. This probably means that
you are not mapping the mode or frequency correctly.
73,
Zev N2WKS
-----Original Message-----
From: Gary D Elliott [mailto:k7ox@pipeline.com]
Sent: Thursday, October 17, 2002 11:27 AM
To: writelog@contesting.com
Subject: [WriteLog] ADIF file
Good Morning Group,
I am slowly converting over to WL on CW & SSB, as of yet I haven't switched
over to WL for RTTY. During the last RTTY contest I used wf1b and then
converted the log to a ADIF file. I inputted the ADIF log into WL and the
entire log went in just fine, However, after each entry there was a big "B"
in red ? It also did not show any of the mults or bands ? My purpose to
input the ADI file was to run some of the stats on the program. Is it not
possible to load this ADI file so that it would look like the contest was
run in WL. Appreciate any comments, Thanks
73 Gary
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
CONFIDENTIALITY NOTICE: This communication and any attachments are
confidential, and are only for the use of the intended recipient. If
you have received this transmission in error, any disclosure, copying,
distribution or the taking of any action in reliance upon this
communication is strictly prohibited. If you have received this
communication in error, please contact the sender immediately and
delete the original message. Thank you.
|