I have successfully used a TS-570D with Writelog and CT. If I remember
correctly the 570 can be set to different baud rates so check to see if
Writelog matches your settings. I think I used 9600.
John
----- Original Message -----
From: "ki6dy" <ki6dy@sbcglobal.net>
To: "Writelog Reflector" <writelog@contesting.com>
Sent: Wednesday, March 05, 2003 06:04
Subject: [WriteLog] Rig Interface to Kenwood TS-570d(G)
Anyone out there have Writelog talking to this radio??? I am attempting to
talk to this rig via COM3 (IRQ4) which is shared with COM1 (IRQ4) that talks
to my KAM OK. I believe I have an IRQ problem even though both WIN98 and WIN
ME show COM3 and COM1 as operational. After setting the Ports through
Writelog it either hangs Writelog or illuninates the CTRL on the 570 with no
frequency information being transfered to Writelog. I also have COM2 (IRQ3)
talking to an FT-1000 with no problems. Wonder if I should switch the
Com3(IRQ4) serial port to Com4(IRQ3) and give it a try????
Thanks,
Bob (KI6DY)
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
|