Re: [WriteLog] Using USB/RS232 adapters for rig control

["Barry N1EU" <n1eu@hotmail.com>]

Yes, the driver installed without a hitch and device manager indicates all 
is copasetic.

The adapter terminates in a male DB9 and I use a straight thru female-female 
DB9 adapter to connect to the FT-1000MP.

Thanks & 73,
Barry N1EU


> From: K4IA@aol.com
> To: n1eu@hotmail.com, writelog@contesting.com
> Subject: Re: [WriteLog] Using USB/RS232 adapters for rig control
> Date: Fri, 7 Nov 2003 08:12:36 EST
>
> I tested that exact same cable for 2 radio operation and got it to work. I
> don;t presently have it hooked up so I can;t compare my settings but I 
> don;t
> recall it being difficult at all.  I run XP Home and had a Field as Radio 1 
> with
> the regular serial port connection and an FT100D as radio 2 on the USB.
>
> Check to be sure you properly installed the USB driver software that came
> with the cable.  Then go to Control Panel - System - Hardware - Device 
> Manager
> and click on the USB Device Controllers at the bottom.  It should tell you 
> if
> you have a problem with the install of the driver.
>
> Radio k4ia
> Craig "Buck"
> Fredericksburg, Virginia USA
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/

_________________________________________________________________
Frustrated with dial-up? Get high-speed for as low as $26.95.  
https://broadband.msn.com (Prices may vary by service area.)

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/