'Rig Type' under Setup/Ports is configured correctly, however this window is
missing an entire column called 'Rig' which used to be there to set the Comm
port to be used for reading the rig frequency, changing bands, etc. Where
did this column go? There must be some way to set the communication Comm
port! In the ini file?
Under Bands/Set Frequency&Mode there is a line near the bottom that says
'Log the frequency of QSO's' and a drop down box that is set to 'Rig on
Comm1'. The only other selection in the box is 'Manual entry'. I used to
use Comm1 for reading frequency, but couldn't get the rig to key CW. Read a
post on the reflector from Wayne once that said Writelog can only work with
'standard' Comm ports and that add on cards may not work correctly, so
that's why I've switched to Comm1 for CW keying and Comm2 for reading rig
info. Now I can't find anyway to tell Writelog to communicate with the rig
via Comm2.
Anyone have any ideas on why I'm missing the 'Rig' column in 10.45M?
Gary, AL9A
----- Original Message -----
From: "Winford Barnes" <winfordb@comcast.net>
To: "'Gary Senesac AL9A'" <al9a@pobox.mtaonline.net>
Sent: March 02, 2004 7:31 PM
Subject: RE: [WriteLog] Writelog 10.45 rig interface
> Under "setup" "ports" look under "Rig Type" there is a drop down menu
> and the 756 pro is listed there. I have mine set to "Auto" for baud
> rate. Make sure the rigs internal menu is set accordingly.
> DE W8XC
>
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Gary Senesac AL9A
> Sent: Tuesday, March 02, 2004 8:06 PM
> To: Writelog Reflector
> Subject: [WriteLog] Writelog 10.45 rig interface
>
> Just updated to V10.45 and can't seem to get it to recognize my IC-756
> Pro for rig control. Not reading the frequency in the band map and edit
> window says 'NO RIG'. Under the Setup/Ports menu there is no longer a
> column for Rig, just CW and DVK. Where do I go to tell Writelog to use
> Com2 for rig control?
>
> Running Pentium III Compaq Presario laptop with Windows ME, Com1 for CW,
> soundboard DVK (works), Com2 to a CT17 (works for DXBase).
>
> Gary, AL9A
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/