I don't have any problem with my FT 920 direct or thru the sound card. I
did find some problems with the built in equalizer so I used the menu to
turn it off and add 225hz of base to the audio as the locals said I was
tinny and thin sounding. Mic is a Heil with HC-4 element. I have two
more Heil boom mic sets and a Telex Contester boom mic set and its the
same with all of them. The telex sounds like a HC-5 type element.
There is nothing noted in the Yaesu service notes or the Yaesu page at
WM7D on mic audio at all. A good ground is almost always required by
Yaesu gear or feedback occurs. I keep a MFJ artificial ground around to
check the ground if there is a problem. The FT 920 has not had any
problems that my earlier Yaesu's encountered.
73 Dave K4JRB
On Tue, 6 Apr 2004 16:06:33 -0500 Bob Naumann - N5NJ <n5nj@gte.net>
writes:
> Apprently, this is a common problem with FT-920's and their mic
> inputs.
>
> I don't know the resolution.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|