Hal...
Hex address for 746PRO is 66h. Also make sure when you click on the
frequency display box it is not set to Manual.
GL in test.
Ron KP2N
----- Original Message -----
From: <halken@comcast.net>
To: <writelog@contesting.com>
Sent: Thursday, February 17, 2005 6:39 AM
Subject: [WriteLog] "No Rig" 746pro - Help for Contest
> Down here at PJ4 setting up - rigs are both 746pro - both showing "No
Rig".
> Hex addresses look correct, screen set to read rig on com 1, baud rate set
to 9600.
>
> WL 10.52F, WIN2K.
>
> Can annone confirm the correct hex addresses to get the 746pro interface
to work? Also, any tips - getting too close to the contest for comfort!
>
> Pse reply direct ---
> Hal
> N4GG/PJ4
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|