Wayne,
After you get everything setup under port settings, etc., be sure to go
to (At the top) Setup, then Save Configuration. That may be the step
you're missing. Just a guess, but maybe.
Hope that helps.
Dick
W0RAA
I set my rig type using the Port Setup screen as "Pegasus" on COM1. My
Ten-Tec Jupiter is connected to COM1, but I am running N4PY software in
Jupiter Logging Mode, which implements an Pegasus API with WriteLog to
allow freq/mode communication between the two applications. This
configuration seems to work, but when I exit and restart WriteLog, the
Port Setup screen reverts to "No Rig" on COM1.
What am I doing wrong? How can I get the Pegasus selection to be saved?
Wayne, WØZW
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|