The TS-850 setting was added by Wayne at my request a few years back.
The default Kenwood setting would not work correctly for split
frequencies. If you typed in a split frequency, it would load up the
VFO's with the right frequencies but would not actually split them.
Other than that, the Kenwood setting worked fine.
73, Tom W2SC
-----Original Message-----
From: Bob Henderson [mailto:bob@5b4agn.net]
Sent: Friday, February 09, 2007 7:07 PM
To: Hal Kennedy; writelog@contesting.com
Subject: Re: [WriteLog] TS-870
Hal
You'll probably see Kenwood & Kenwood TS850 on the list. So far as I am
aware all Kenwood radios use the same command set. I am not sure why
the 850 has a specific listing. Maybe it's the exception. I've used a
TS870 successfully with the vanilla Kenwood selection, though not for
some time.
73
Bob, 5B4AGN
----- Original Message -----
From: "Hal Kennedy" <halken@comcast.net>
To: <writelog@contesting.com>
Sent: Friday, February 09, 2007 9:09 PM
Subject: [WriteLog] TS-870
> Can someone confirm for me that a TS-870 will fire up using the
setting
> for
> TS-850? TS-870 does not show up as one of the supported rigs.
>
> Thanks
> Hal
> N4GG
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|