Gordon, I am using a Navigator and MMTTY, the trick I found is to select
from the RTTY screen in WL the port you have your FSK assigned to, and all
seemed to work. Maybe not the "right way", but it works, and should work
with your Rigblaster.
If you have a problem doing that give a shout direct, and I can walk you
through it..
73 and C U in the test.
Len
----- Original Message -----
From: "N9BHH" <N9BHH@ARRL.NET>
To: <writelog@contesting.com>
Sent: Friday, January 04, 2008 10:20 PM
Subject: [WriteLog] Help with Setup of WL with IcomPro3, FSK, Rigblaster Pro
>
> Hi Folks,
>
> I am tearing my hair out trying to get WL set up for FSK using a
> Rigblaster Pro and an Icom 756PROIII. I had WL working beautifully when I
> was in AFSK mode. However when I added the second serial cable in order
> to enable FSK keying, I cannot get the rig to transmit RTTY in FSK. FSK
> and rig control DOES work fine with standalone MMTTY. Here is what I
> understand:
>
> 1) With the Rigblaster Pro, you cannot have FSK and Rig Control share the
> same serial cable (com port), they must reside on separate com
> ports/cables.
>
> 2) Rigblaster gives you the option of putting Rig Control on either Com
> port A or B (but FSK then must be on the other port).
>
> Here is how I have my Rigblaster Pro set up (again it works fine with
> stand alone MMTTY):
>
> Rigblaster Comm A: FSK, PTT, and CW - this corresponds to Comm 2 on my
> computer
> Rigblaster Comm B: Rig Control - corresponds to Comm 1 on my computer
>
> For the life of me, I cannot get Writelog properly setup to work; I can
> get PTT to work, but I don't hear RTTY tones in "monitor", just a steady
> tone. I have tried just about every combination possible without
> success - including setting parameters in RTTYrite and in the MMTTY engine
> that comes with WL.
>
> I understand that I need to set Comm one to 756PROIII, no Poll, 9600 baud,
> no Comm PTT (this is the port for Rig Control)
> Comm two on the computer is set to radio button checked for CW, Auto,
> Poll, Yes on Comm PTT (If I also choose 756PRO3 for this port, then PPT
> locks up)
>
> The PTT setting is the "all mode PTT" (which worked great before in AFSK).
>
> Any help would be appreciated, I have searched all the archives and
> googled the internet but did not discover a solution or documentation
> (which somewhat surprises me since I think this is very popular
> combination of equipment).
>
> Thanks,
> Gordon Bousman, N9BHH
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|