The CommSlot entries need to be under the ports section
[PORTS]
CommSlot1=5
CommSlot2=1
CommSlot3=2
CommSlot4=6
Dan K0TI
-----Original Message-----
From: writelog-bounces@contesting.com [mailto:writelog-bounces@contesting.com]
On Behalf Of Barry Middlebrook
Sent: Thursday, April 02, 2009 5:52 PM
To: writelog@contesting.com
Subject: [WriteLog] Cannot Get Com 6 and Com 7 To Be Recognized
I purchase Writelog to give it a try for contesting as VE6SV has been using it
for years so I wanted to get some practice and experience with it.
I cannot get it to recognize my com port devices.
My PC is a custom built-up unit running XP.
- Com 1,2 ports are on the mother board
- Separate Card PCI Bus Lava card Com 3 and 4
- RIGblaster duo unit form West Mountain Radio connected via USB that shows up
as Com 5 and Com 6 for the two radio interfaces
Within my station I use Com 3 for my rotator and Com 6 and 7 for my two
Radio's, an IC-7000 and IC-775DSP(Being replaced with a new IC-7600 shortly).
I only have the IC-7000 connected up right now to Com 6.
The Writelog Rig Setup screen only shows ports Com 1 through Com 4. I modified
the /Windows/writelog.ini file to have the lines
[Rigs]
CommSlot1=5
CommSlot2=6
But this seems to have made no difference.
It also doesn't look like my Com 3 Yaesu with Rotor EZ interface is NOT being
recognized either, selecting Com 3 and DCU for the options.
I am stumped. My system works well as-is with N1MM, Logger32 and YPLog.
Within my System Configuration all of the ports are recognized in the windows
Control Panel System Hardware Configuration Device Manager and all look OK.
I use all of the ports for other interfaces and am very adept at dealing with
computer hardware and software configuration, but I have to admit that I am
stumped as to why I cannot get Writelog to be configured to recognize my serial
ports.
I am going to give one last try to see if someone out there has a workable
solution or I will simply shelve Writelog and use another. It will have been a
waste of good money though and I really wanted to give it a sincere contesting
try here at my station!
Any suggestions?
Barry Middlebrook, P.Eng
VE6TN
RAC Director, Alberta, Northwest Territories and Nunavut Radio Amateurs of
Canada (RAC)
Amateur Radio . . . a community resource!
<http://www.mts.net/~warc/hamfest/>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|