Hello Group,
I purchased one of K1NU's dual cw & rig control cables and having problems with
getting it to key my Radio a ICOM IC-761. I am using XP as my operating system
along with WriteLog version 10.53.
The cable is plugged into comm 2 and the cable reads the radio frequency just
fine and changing bands the frequency follows right along. However, when I
plug the 1/4" phone plug into my IC-761 KEY jack it keys the radio, unplugging
the 1/4" plug from the radio and it goes back to normal in receive.
I have exchanged a couple of e-mails with K1NU and have failed to get the cable
to work. He had me try some different settings that I normally wouldn't use
such as in the port setup to "Comm PTT = NO" and "All mode PTT not checked" The
results are the same as before. He suggested that it might be a writelog ini
issue.
One thing that is rather strange is that when I am in "Ports" setup in Writelog
and I put a check mark in the CW field of comm 2 and then save the settings in
save configuration and bring WL ports back up the little check mark I had put
in for CW is gone, disappeared ?
Looking for someone who is using one of these dual cw and rig control cables
and how you set it up in WL, especially what your ini looks like. Appreciate
any suggestions on getting this cable to work. Thanks
73 Gary K7OX
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|