:::: Thank you so much Mark.....that did the trick.
Apparently there is a minor "bug" in the setup area that causes you to need
to set the baud rate manually, at least for some radios. I set it for 4800
manually for my FT950, and now all works perfectly.
Thanks to everyone who responded. This reflector is a great source of info!
BILL K2OWR
...........................................................................................................
>
> Bill, with my Icom Pro III, under port selectin/baud rate, I need to
> select the radio's actual baud rate, "auto" does not work.
>
> Hope this helps
>
> 73, Mark WA9IVH
>
>
> On Nov 17, 2009, at 9:13 AM, Bill K2OWR wrote:
>
>> :::: Uh,oh. Nobody?......I'm in trouble.
>>
>>
>> I wrote:
>>>
>>>> :::: I am using Com1 on my computer, which I know works because I use
>>>> it for Ham Radio Deluxe all the time.
>>>> My interface cable is a 9 pin serial and I have checked for end to end
>>>> continuity on all pins, and it's fine.
>>>>
>>>> I select Com1 in the setup menu, choose my radio, (Yaesu FT950) and hit
>>>> ok.
>>>> The WL screen says "no radio" and when I click on a dx spot, it appears
>>>> in the logging area, but does not make the radio go to the frequency. I
>>>> don't believe the radio is "handshaking" with WL at all.
>>>>
>>>> Any ideas....anyone?
>>>>
>>>> BILL
>> _______________________________________________
>> WriteLog mailing list
>> WriteLog@contesting.com
>> http://lists.contesting.com/mailman/listinfo/writelog
>> WriteLog on the web: http://www.writelog.com/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|