At this point I think the answer is no.
I am just anal, or trying to be, about what number I use for virtual and
physical com ports this time. I use an Edgeport 8 for accessory physical
ports such as rotors, amps, and watt meters. I would like to keep those in
a numerical order I can remember easy.
I can live with it I guess.
73 John wa5zup
-----Original Message-----
From: Larry stowell [mailto:lclarks@nc.rr.com]
Sent: Thursday, July 08, 2010 3:55 AM
To: 'wa5zup'; 'Writelog contesting.com'
Subject: RE: [WriteLog] Rotor Control Port Number
John
I posted this a couple of days ago and haven't seen any response. If you
find and answer let us all
know.
Thanks
73
Larry K1ZW
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com] On Behalf Of wa5zup
Sent: Wednesday, July 07, 2010 8:57 PM
To: Writelog contesting.com
Subject: [WriteLog] Rotor Control Port Number
I saw a post not long ago similar to this very question I think. Could not
find any answer posts.
I have been using com port 6 for Writelog rotor control for years. I am
rearranging com ports for a SO2R controller. The rotor port drop down menu
only goes to com 8 in Writelog. I would like to move the rotor to port 10.
I tried changing Writelog.ini from Rotor Port=6 to Rotor Port=10 but that
did not work.
Anybody know if it is possible to move rotor control above com port 8?
73 John wa5zup
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|