I am tearing my hair out trying to get CAT control to work on Writelog with
my USB to Serial Converter.
I am setting up a Windows 7 laptop for a friend. I have a USB Port Expander
plugged into one of the USB ports on the laptop. I have 3 USB to Serial
Converters plugged into the expander.
The come up as COM 5, 6, and 7.
I am trying to set them up as follows:
RTTY FSK / PTT - COM 5
Radio CAT Control - COM 6
CW Keying - COM 7
The RTTY and CW Keying ports work fine. I am actually using EXTFSK for
COM 5 but that all seems to be working.
However, whenever I try to setup COM 6 for CAT Control in the Ports Setup
in Writelog, I get Access Denied.
I've gone into admin mode, revealed all my hidden COM ports, deleted them,
and started over fresh several times adding the USB converters one at a
time. Again, the RTTY and CW keying work but I always get Access Denied when
I try to set up the COM 6 to for CAT Control.
Is there something I am missing? Do I need to enable something in
Writelog.INI?
Lots of hours in this. Any suggestions welcome.
73,
AL, K0AD
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|