Thanks Don - I finally had a chance to sit down and apply your suggestions.
First thing, I got rid of all the extraneous writelog.ini files, then edited
the correct one by removing all the RTTY, RTTY-Rite, and RTTY-Rite clone
sections. Then opened writelog as an administrator. Saved everything and
exited the program - reopened (not as admin) and its working like a champ.
Now all set up for next weekend's NAQP-CW.
Tom Shelton, ND3N
-----Original Message-----
From: WriteLog [mailto:writelog-bounces@contesting.com] On Behalf Of Don AA5AU
Sent: Monday, July 20, 2015 12:46 PM
To: Tom Shelton; WriteLog@contesting.com
Subject: Re: [WriteLog] Getting error with RTTY
I don't know what could have caused these errors, but one way to "start over"
on RTTY is to delete the [RTTY] sections in your writelog.ini file and then
restart WriteLog. If you tried opening a cloned Rttyrite window, then there may
be more than one [RTTY] section in writelog.ini. There may be [RTTY], [RTTY2],
etc.
Open writelog.ini in Notepad, find the [RTTY] sections, highlight them and
delete them. Then restart WriteLog and start configuring your Rttyrite windows
again.
For information on using MMTTY and 2Tone with XMMT.ocx, see this tutorial:
http://www.rttycontesting.com/tutorials/writelog/xmmt-support-for-mmtty-2tone/
For more information on Cloned Rttyrite windows, check this out:
http://www.rttycontesting.com/tutorials/writelog/rttyrite-clones/
Something else you can do and this is a bit more radical, is to delete or
rename writelog.ini, then restart WriteLog. This creates a new writelog.ini
file.
73, Don AA5AU
From: Tom Shelton <gl1800winger@verizon.net>
To: WriteLog@contesting.com
Sent: Monday, July 20, 2015 4:31 AM
Subject: [WriteLog] Getting error with RTTY
In setting up for the NAQP RTTY, I wanted to try to clone a second RTTY
decoder. So, first I got the primary one up using 2-Tone. Then I cloned a
second window with the intent on using MMTTY there. When I did that I got an
error window. When I cleared the error window, it completely shut down all my
RTTY windows. I tried to open a new window for RTTY and I got the error again.
I shut down WL (11.27H) and reopened. Same error window.
After playing around for a bit, trying all kinds of stuff like reloading WL,
checking the ini file, restarting the computer, updating both MMTTY and 2-Tone,
and running a registry clean-up, I found the only thing that worked was running
WL as administrator. I never did get the cloned window to work.
Any ideas?
Tom Shelton, ND3N
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|