Just finished setting up my messages in Writelog for next weeks WAE RTTY
contest.
When I test them with my radio connected to a dummy load and set to 10
watts I notice that sometimes the transmitting message stops briefly
then starts up again. The mark tone is always on.
Also sometimes after the message transmission is finished the mark tone
remains on for about 10 sec.
This is not normal and I have no idea what the cause is or how to fix
it. Here are my messages...
2. %R CQ WAE DE KI8W KI8W CQ %E
3. %R QRZ WAE DE KI8W %E
4. %R %D 599 - 599 %3 DE KI8W K %E
5. %R QSL TU %D QRZ DE KI8W %E
6. %R RST? %E
7. %R NR? %E
8. %R 599-599 %E
9. %R %3 %3 %E
10. %R DE KI8W KI8W KI8W %E
I also get this message... RTTY Memory %E not at end of message. Do you
really want that? Yes/NO
I checked I have no stray %E in any of my messages.
--
73
Thom KI8W
"Living deep in the black hole of RF"
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|