Did not have it set for PC generates CW... Fresh look when I got a chance...
Will WC2L
On 5/25/2018 9:55 AM, Robert wrote:
In your K3
Check the PTT and CW settings on incoming serial port
-----Original Message-----
From: WriteLog [mailto:writelog-bounces@contesting.com] On Behalf Of William
Liporace
Sent: Friday, May 25, 2018 3:57 AM
To: writelog@contesting.com
Subject: [WriteLog] K3 steady keying
I just started WriteLog. This is a new setup. Full paid version.
As soon as I enable the com port and hit apply, the radio goes into a steady
keying state. I know it is something simple.... The radio and WriteLog are
new to me...
FYI, N1MM works just fine.
TNX Will WC2L
--
William Liporace WC2L
http://www.wc2l.com or http://dxc.wc2l.com AR-Cluster Node telnet
dxc.wc2l.com or 144.93 MHz wc2l@wc2l.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
--
William Liporace WC2L
http://www.wc2l.com or http://dxc.wc2l.com
AR-Cluster Node telnet dxc.wc2l.com or 144.93 MHz
wc2l@wc2l.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|