There are several problems with the VFO control part of DigiRite. I wish
they would just pirate the open source WSJT.
Rick/WU6W
-----Original Message-----
From: WriteLog <writelog-bounces@contesting.com> On Behalf Of K2RD - Ira
Stoler
Sent: Monday, September 2, 2019 1:44 AM
To: writelog@contesting.com
Subject: [WriteLog] Digirite doesn't shift/split FTdx5000
When configuring Digirite for either split or shift to move transmitted tone
above half bandwidth point for harmonic suppression the radio doesn't
respond properly.
1) In the case of split setting the VFO doesn't split and neither does the
tone transmitted shift upward it remains as set in TX freq box on Digirite.
2)In the case of shift the VFO A shifts but the transmitted tone remain
unchanged.
Used 333 hz tone to test.
I tried same with FT991a and all works fine.
My set up is FTdx5000 and microKEYER III and WIN4YAESU Suite but did test
with/without W4Y Suite with same result.
Same function works properly using WSJT-X standalone.
Thanks and 73
Ira K2RD
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|