I think I have had that problem also, but I would check that you have
the proper serial port picked, and that you have selected DXP-38 in the
TU-Type selection, other than that I don't know what else. I think it
happened when I also remodeled the ham desk! One other thing you can
try and it will help is if you have the old DSPWin3.0 program run it.
If you are on the wrong port it will tell you.
Also make sure no other program using the DXP-38 is running.
Good Luck
Val
N7VGO
On 8/14/2020 3:40 PM, Adam Tarpley wrote:
Hello all,
After a few months of shack renovations I am getting set up for the
contest season and am reinstalling my rttyrite clones.
I run mmtty in one window, 2 tone in another, hal dxp-38 in a third
and in 4th window I have an st-8000. Everything worked fine together
when I disassembled the shack right before covid. Now, when I run
rttyrite, the dxp-38 goes to stby mode when I initiate the clone
window. I remember having this issue in the past and found the
solution online but for the life of me I can find the solution again.
Any thoughts are appreciated. I know this is a solvable issue as I
have seen how to fix it in the past, I just cant find it now. As I
recall, I had to change some things in my writelog ini file
73
Adam - W4TTY
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|