I assume you are activating the K3/K4 DVR via the Elecraft commands you
entered into the INI file.
If so you will need to assign a key to the Elecraft command to stop TXing.
At least I think so
The ESC key is assigned to stop the Macros generated in WL
Rich
On 2/25/2023 11:24 AM, Bob Wolbert, K6XX wrote:
Thanks to the helpfulness of the subscribers, my WriteLog is behaving
itself and acting as a logger should. I needed that information on the
.ini file since, as all of you know, a proper .ini is crucial to
program operation.
I did not understand where/how to find the file; now that you showed
me, it is just a matter of time/experiments getting the program
playing efficiently. Fortunately, two extremely rare (for here) but
timely "snow days" let me concentrate on the program. It is now
working well for me.
That doesn't mean that I'll leave well enough alone, however! May I
lean on the reflector for a few more questions?
1. Multiplier Window in WPX contests. It opens, but WL is unresponsive
until the window is closed. Is this normal, or is there a setting?
2. K3 or K4 DVR Message kill. Once a DVR message starts, it plays to
completion: ESC won't stop it. How can this be fixed? Note that
pressing the footswitch causes the rig itself to halt the message.
3. Are there setting that will prefill Log Submission Details,
specifically Power, Xmtr, and Operator (single vs multi-op)?
4. May we enter comments to document our .ini files?
5. UTC display, with seconds?
Finally, in a couple of the direct replies to my help request, some
mentioned disabling the "C" and "Country" entry fields for each new
contest. There is a setting for that:
[Multipliers]
ShowCountry=0
does the trick.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|