question on sub-bands
if I click show bands, it all appears good.
However, running CW and WARC bands, clicking on callsign in the bandmap
doesn't work.
(this is on control site running remote)
I went to edit sub-bands and no WARC bands appear there
what's Packet submenu there?
I am in DXpedition mode for log
Robert W5AJ
On Mon, Feb 19, 2024 at 10:17 AM Jay <ws7ik7tj@gmail.com> wrote:
> Jim
>
> Run the program Writelog Edit Sub-bands. You will see CW 28000 to
> 29700 as CW is authorized in that entire Range of course.
>
> Change it to what you want.
>
> Or far easier just change your Cluster to not do SSB spots during a CW
> contest.
>
> 73 Jay
> WS7I
>
> On 2/19/2024 7:57 AM, Jim Reisert AD1C wrote:
> > I was operating the ARRL DX CW contest this past weekend but was still
> > seeing "needed" spots in the Packet Spots window but in the SSB part
> > of the band. These were selected:
> >
> > Bands: Follow me
> > Mults Only
> > In-band Only
> >
> > Where are the band limits defined? For example, 10m CW should only be
> > from 28000 to 28299 KHz, I should never see a needed mult spotted with
> > a frequency higher than this.
> >
> > Thanks - Jim
> >
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|