Yaesu
[Top] [All Lists]

[Yaesu] LOCO FT1000

To: <yaesu@contesting.com>
Subject: [Yaesu] LOCO FT1000
From: dgmaley@soli.inav.net (David G. Maley)
Date: Thu, 11 Jan 2001 07:59:49 -0600 (CST)
Kim;
Yaesu usuially reserves this type of display error
for an out-of-lock condition within the synthizer.
Dave.
WA0ZZG


On Wed, 10 Jan 2001, Lic. Andres Kim XE1KIM wrote:

> Hi Guys hopefully someone can help me..
> 
> My FT1000 (Serial 0G0) does not stop
> blinking BLINK BLINK BLINK all the time
> of course no TX or RX, if I disconnect the
> unlock signal from the control unit of course
> the problem goes away but still no RX on the main IF
> no tX also, but I do hear on the RX2 unit, but thats
> when I disconnect the unlock wire from control unit.
> I thought it was the local unit so I bought it from
> YAESU in Cal., YEP problem did not went away,
> Since I cannot send my radio to yaesu in the USA
> Because I bought it on a flea market so no import
> papers, and there is no one who can help me
> here I´m trying to replace unit´s, again I have just replace
> local Unit, Do you know what unit do I have to replace
> (no compromise) I need my ft1000 running, Im almost 
> sure that IF and RF unit´s are not the problem, maybe
> control unit, but again maybe control unit is receiving the "order"
> to block IF and TX, I hope I explained myself and if you
> know what unit to replace 
> If I turn on the radio with unlock signal disconnected no RX or TX on main
> If, if I press DUAL I do hear RX2 little bit like i cannot find the signals
> correctly, but i do hear, if I re-connect unlock signal from control unit
> the problem starts BLINK BLINK BLINK BLIK also the display, and of course
> no TX or RX.
> 
> Best 
> Andy Kim
> XE1KIM
> 
> 


--
FAQ on WWW:               http://www.contesting.com/FAQ/yaesu
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:                 owner-yaesu@contesting.com


<Prev in Thread] Current Thread [Next in Thread>