Many thanks to John, N4QWF, for helping me solve the problem. It took a
processor/memory reset. Now all's well.
Bill
-------- Original Message ----
Can anyone give me advice? Have borrowed an FT-736R that seems to work
well, except in satellite mode. When I set Rx mode, it works fine, but
when I try to set Tx to a band/freq, all I get is ERROR on the frequency
display. If I do a memory check, it says 50MHz on one memory, which
isn't even installed, and I can't seem to change it. Any ideas would be
most welcome. In non-SAT mode, both VFO's work fine. Yep, I've read the
manual for what that's worth.
Net question is, why do I get ERROR when going to Tx Mode?
Thanks, Bill
|