[Top] [All Lists]

Re: [Amps] SB-220 no output

To: Glen Zook <>
Subject: Re: [Amps] SB-220 no output
From: Warren Volz <>
Date: Tue, 25 Jul 2017 12:29:59 -0600
List-post: <>

Yes ok, so it's only to give you a general idea on the power not actual
numbers. That explains it. 


On 07/25/2017 7:47 am, Glen Zook wrote:

> The meter reads "relative" power and, as such, the meter calibration has no 
> meaning in terms of actual power output other than a higher reading, at any 
> particular setting of the "sensitivity" control, means more power output. 
> Glen, K9STH  
> Website: 
> -------------------------
> FROM: Warren Volz <>
> TO: amps <> 
> SENT: Tuesday, July 25, 2017 2:01 AM
> SUBJECT: [Amps] SB-220 no output
> All, 
> I ran into another hurdle with the SB-220 and am hoping someone has some 
> wisdom. If I run RF through the AMP without power applied the relative power 
> meter works and I can match my dummy load without issue. Side note, is the 
> relative power meter supposed to line up on the bottom scale with actual 
> forward watts? Ie: 100 Watts = 100 on the multimeter scale? Once I enable my 
> rigs "amp keying" mode and transmit with anything from tune mode to a carrier 
> I see high SWR and 0 output after the amp. 
> To troubleshoot, I hooked up my DMM and triggered the keying interface so 
> that the relay(s) engaged. I've confirmed that both are working correctly. 
> Oddly if I put the DMM in continuity test mode and trigger the TX mode on the 
> amp I get a beep. So, the RF is blocked someplace inside the tank circuit or 
> band switch? That's my best guess. Or is it possible that a bad tube would 
> cause these symptoms? There is no deflection on the plate meter when I've put 
> RF in. Does that mean the tube is being held in cutoff? 
> Thanks for the help again. It's challenges like this where I wish I had a 
> local elmer to help out!
Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>