I thought the definition of a half sloper was that the coax shield was
bonded to the top of the tower.
I use a quite a number of Balun Design baluns and can find no fault with
them keeping in mind that I have not evaluated them on the bench.
A friend of mine replaced a troublesome Maple Leaf design balun on his OCD
dipole with a Balun Design unit and is pleased with the result.
Contacts are made without WebSDR or RHR or FT8.
From: TowerTalk [mailto:firstname.lastname@example.org] On Behalf Of Jim
Sent: December-08-19 2:28 AM
Subject: Re: [TowerTalk] Shunt Feed Woes
The N9NB/W5JAW installation seems not bond coax shields to the tower at
top and bottom, which is in conflict with long standing good engineering
practice for lightning protection. This bonding, combined with running
the coax in close proximity to a tower leg, puts the coax at the same RF
potential as the tower, point-by-point along the height of the tower,
and because the tower has a far greater cross section, it carries nearly
all of the current. So if these coax runs were properly bonded, the only
need I see for common mode chokes is at each Yagi feedpoint to prevent
noise coupling and null filling due to common mode current at the
operating frequencies of those antennas, and these chokes would be wound
for those operating frequencies, not 160/80M. Perhaps I'm missing
something about physical construction of the antenna(s) in question.
I have a very low level of confidence with respect to Balun Designs
products. That's based on one of their units (brand new, no possibility
of damage) that an NCCC member who's building a station in the Caribbean
asked me to measure. It looked NOTHING like its data sheet that was on
their website at the time. I circulated that data to several trusted
engineers, and within a few months, the data sheet plot had disappeared
(I suspect that one of those engineers asked them about it). My
assessment is also based on things I've read on their website about
chokes that indicate that they don't understand how chokes work.
73, Jim K9YC
On 12/7/2019 11:30 PM, K9MA wrote:
> The shunt chokes may not be as critical with the slopers, as the voltage
> near the top of the tower is probably lower than with a shunt fed tower.
TowerTalk mailing list
TowerTalk mailing list