[Top] [All Lists]

Re: [TowerTalk] Compression-type PL-259s

Subject: Re: [TowerTalk] Compression-type PL-259s
From: Ian White GM3SEK <>
Reply-to: Ian White GM3SEK <>
Date: Thu, 20 Jan 2011 23:05:26 +0000
List-post: <">>
Pete Smith wrote:
>Has anyone had any experience with compression-type PL-259s?  I haven't 
>had any in my hands yet, but they appear in places like the Farnell 
>catalog in the UK, and use a compression scheme similar to compression 
>Type N connectors, which seem to be much more common.  I would do 
>almost anything not EVER to solder another PL-259 braid connection,

Highly recommended. I used the compression sleeve N type for years, and 
was very happy when they also became available in a PL259.

Cable prep consists of one flush cut through the jacket, braid and 
insulation, then push the 'top hat' ferrule under the braid (flare the 
braid very slightly to make sure that the ferrule slides cleanly 
underneath and doesn't catch). When the pressure sleeve is fully 
tightened, the cable anchorage is very strong and completely waterproof.

However, this is still a PL259 so the center pin has to be soldered and 
it doesn't have a water seal inside the outer ring. Waterproofing will 
thus be little different from a regular PL259 - it's as good or bad as 
you make it.


73 from Ian GM3SEK

TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>