My Omni VI Plus has some kind of roofing filter in the N-1 position. I need to open it up and see what brand and type of filter it is. It does not appear to work very well. Best regards - Bry Carling
How does the audio sound? You are starting to make me wish that I had an Omni VII but the ergonomic layout of the front panel would be a concern also. Best regards - Bry Carling
The Omni VII discussion is very informative. I need encouragement when it comes to accepting the ergonomics of most modern rigs. The FT450 felt like I was burned with its horrible menu system. I actu
Which model number INRAD filter do I want for 600 HZ roofing in my Omni VI Plus please ? Sorry for my ignorance but they list so many, and I want to be sure... Of course, I could also put the money t
I have a Tentec 422 Centurion that is blowing the main 20 Amp fuses... Looking for insights to this amp failure. It started spontaneously. I can turn on the main power OK and the filaments light up o
Thanks Rod and PC. I already tried disconnecting the plate transformer secondary and it still blew fuses. I think I have a bad transformer. I will check it further but looks like a serious expense to
Thanks Bob, but the power transformer is shot. It spontaneously died for no apprent reason. Tubes are not shorted, and the rectoifoers amd cap are intact. One of the two primary windings has shorted
Thanks so much Bob... The choices are rough - $500 plus shipping for a new transformer from Tentec or $385 plus shipping both ways for a rewind job! Yes, we get lightning, but this occurred when ther
Thanks - I really appreciate the sage advice from you guys... it's a pity that the primary fuses and inrush circuit didn't properly protect the transformer, but to be fair it is an old one. Serial nu
Thanks Stuart. I will probably go with Gary Brown, WZ1M. Hammond does not answer their phone message sor e-mails, and Tentec wants $565.50 plus crating and shipping. A bit prohibitive considering tha
Thanks Cecil - yes I will try to get mine overwound slightly while it is being rewound. Hammond is the seller of the Dahl transfoemer line now, but they are not taking care of business. Zero response
The S meter on my Omni 6 plus never goes above S 7. Any ideas what causes it? Bry Carling http://www.af4k.com http://alltheaboveband.com I think it's kind of nice to have some S meter reading when I'
Yes, I will try that. Maybe it took a bump in shipping. Bry Carling http://www.af4k.com http://alltheaboveband.com Alignment/meter calibration would be my first thoughts... Cecil Sent from my iPad On
Yes. It does not appear to be an alignment issue. The same problem prevails on all bands. Also my CW keyer speed range is way too fast. Therefore difficult to adjust. Bry Carling http://www.af4k.com
Exactly what I have... Thanks. Bry Carling http://www.af4k.com http://alltheaboveband.com A mis-alignment of the S meter would be the same on all bands... ____________________________________________
Curt, it sounds RF could be getting back into the letter wiring and triggering it falsely. Did you check the ground wiring. Bry Carling http://www.af4k.com Sometimes the keyer on my recently purchase
This is getting fairly esoteric. Like... If a tree falls in the forest and nobody is there to listen does it make a sound? Answer: Yes of course it does. Bry Carling http://www.af4k.com http://allthe
Unsubscribe bcarling@cfl.rr.com They are alive and well, below are the following parties that distribute their product. 73, Ron, N5QV www.WB0W.com<http://www.WB0W.com> www.PL-259.com<http://www.PL-25