Mine was about 200 HZ off on all bands when I bought it from a ham. The a meter readings were horrible too. Both were fixed properly when I sent it in to Sevierville. Best regards - Bry Carling
Sorry to digress but I have similar questions... Will HRD 5 work with my Omni VII arriving this week? I'm not sure if it's coming with an interface cable for my Win8 laptop. Was the serial interface
Jim is right. Bad form. Some of the worst offenders I hear on the air are actually overseas or even Dexpedition stations running contest. Best regards - Bry Carling
Yes - realistically (!) businesses have to do what they have to do. Radio Shack just closed thousands of stores. I guess Elecraft has hurt TT a lot. I bought a used Omni VI Plus last year. I had alwa
My guess is their radios have not been selling well because they didn't advertise them, and I also notice that some makers if ancillary equipment such as automatic tuners do not even mention interact
Hello Fellers - perhaps some seasoned TT op can help me learn something here... I have just acquired a used OMNI VII. I know the band conditions are horrible, but I am hearing something that bothers
Great, and thanks Paul - I will look up how to check and update the firmware later today and also see how to adjust the DSP. Other than that the radio is much more intuitive than most nowadays... is
The MASTER RESET seems to have alleviated the messy signals the best that I can tell. Previous owner didn't use it much and it looks like new, alogn with the 708 mic etc. I think I may need a small b
Thank you so much Bob... It shows VER 1035-588 Thanks so much for showing me the settings. I will comp[are to mine and salso give a thorough listen to the CW note on rcv after this rest. So far it ha
I suspect he is overlooking something. I use a very inexpensive interface with my Omni six. Nothing fancy like that one. When I was first setting it off I ran into some settings and connection issues
Hello, I now have a clean sounding OMNI VII after doing a master reset. Thanks guys. Does anyone know how to invoke the 500 Hz Collins filter once it is installed and enabled? I have read the manual