HiI am in search of two of the small, 13/16 inch diameter, brownish/grayish pointer knobs that are used on a Corsair II. The shiny disk part of the knobs have been lost. I do have a pair of the same
I have an OMNI VII as new, not a scratch with the narrow CW filter, factory box, manual, Ethernet manual and DC power cord. It has been used as second to my ORION II and has seen very little use. I o
HiI have a Ten Tec Corsair II that has some AGC and S meter problems: AGC toggle switch has no effect at off or slow. At fast it will cycle from no signal to pinned S meter then de-sensed fully and r
HiAnyone out there who knows Drake C Line that can answer an easy question about the slug tuning of the coils? Or lead me in th right direction is fine, too. In short, page 5-2 paragraph 5-8a of the
For sale Ten Tec TITAN amplifier, 160-10 meters, legal limit, QSK. Non smoking environment. Excellent condition. Best offer, reply off list. Dave in NH
Another view on the sticky tuning of the PTO: That is if the knob isn't loose up and down, then the PTO only needs to be cleaned of the old sticky grease. Towards that end: I have had great success b
HiSomewhat off topic, but hey... Anyone with a relatively new Tacoma WA telephone book that could look up a residential number for me? My on line actions have not been successful. Thanks, 73 de Dave
To: the list and ditsnbitsI have an OMNI VII with the 300 Hz filter, this is a super rig on CW. Easy to use, hot receiver, and excellent DSP. I also have an ORION II it is also equipped with a narrow
Ten Tec Corsair II WANTED...SWAP. I'd like to find a Corsair II HF transceiver. In that direction I have a pair of YAESU TWINS from the 70's to trade along with a pristine TT OMNI, the last in the se
HiI have a Heath 2060 antenna tuner that I would part with if I can find a TenTec Corsair II to fill the space. The tuner is in excellent shape (pix available). I would like to try another Corsair II
HiI have some interest in increasing my electric bill. Towards that end a legal limit amp with QSK is a good solution. I'd consider swapping around an Orion II with built in tuner and 300 Hz CW filte
HiI have an immaculate Ten Tec OMNI series C transceiver that works flawlessly. I also have an Argonaut V that I'd like to get some more power out of. Something like a Tokyo High Power or Ameritron o
HiI am looking for a 250 Hz Ten Tec filter used in TT rigs for eons. I have another idea for it I'd like to try. I'd like to swap a PALOMAR R-X Noise Bridge for the filter. It can be used to determin
HiI am looking for a 9 MHz, 250 Hz Ten Tec filter used in TT rigs model number 219. I have another idea for it I'd like to try. I'd like to swap a PALOMAR R-X Noise Bridge for the filter. It can be u
HiOMNI VII Upgrading softwareThe manual says on page 33 to "Turn the transceiver while holding down the MNU button" in order to get into the "Flash Update Mode". ( bottom right column of page 33). In
Wanted: 250 Hz Ten Tec filter model number 219, 9 MHz filter. I have another idea for it I'd like to try. I'd like to swap a PALOMAR R-X Noise Bridge for the filter. The noise bridge can be used to d
HiWhat if I want to update the flash memory, but when I go thru the sequence to enter the Flash Update Mode, it will not indicate "Flash Update Mode"? What if at turn on the rig reverts to "Radio not
HiI asked a question yesterday regarding resetting the OMNI VII, thanks to those who did respond. It didn't solve the problem, but led me in the right path. The solution lay in downloading the intern
HiMy other Ten Tec rigs all seem to have silent Morse keying using the internal keyer but, with the ORION II I hear a keying relay click with each CW element I send. No big thing, but I prefer the si
HiJust loaded v. 2.038k into my Orion II. Easy as usual but, no RIT or XIT! Oh, it will change +- 10 but that is all. Tried a Master reset twice without getting rid of settings and memories. Anyone w