Search String: Display: Description: Sort:

Results:

References: [ +from:RMcGraw@blomand.net: 2582 ]

Total 2582 documents matching your query.

361. Re: [TenTec] PSK and Argo V help? (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Sun, 05 Oct 2003 08:39:17 -0500
Rick: Crank the VOX gain to max, be sure the anti-VOX is off and set the DELAY to min. Adjust the sound card output until the unit keys reliably and then adjust the transmit audio for something less
/archives//html/TenTec/2003-10/msg00073.html (9,314 bytes)

362. Re: [TenTec] PSK and Argo V help? (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Sun, 05 Oct 2003 21:39:54 -0500
The sound card is line output level and the Argo V has a mic input level. There is typically some 30 to 40 dB difference between the two. A pad is required to maintain signal-to-noise ratio and thus
/archives//html/TenTec/2003-10/msg00119.html (13,763 bytes)

363. Re: [TenTec] FS: Hercules II Amplifier etc.<<URGENT>>> (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Sun, 05 Oct 2003 21:33:12 -0500
Yes, but balancing the load between the two supplies can get tricky. You need to establish a common point for + and - and make sure leads from each supply to the common points are exactly the same. T
/archives//html/TenTec/2003-10/msg00120.html (9,811 bytes)

364. Re: [TenTec] New group for Orion (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Sun, 05 Oct 2003 21:45:27 -0500
Why should I have to visit 6 sites on Yahoo to get the info I need on various radios? Well, it's been done, split several ways so here we go re-inventing the wheel again. CLICK CLICK CLICK. I guess t
/archives//html/TenTec/2003-10/msg00121.html (10,535 bytes)

365. Re: [TenTec] PSK and Argo V help? (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Mon, 06 Oct 2003 17:47:40 -0500
Rick, OK I understand. However, your statement in this response says the AUX1 jack accepts 2 V P-P, then you stated that the sound card level is near minimum. This raises the question "are you using
/archives//html/TenTec/2003-10/msg00177.html (16,639 bytes)

366. Re: [TenTec] Orion Contesting.com Reflector (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Mon, 06 Oct 2003 18:26:20 -0500
THANKS Jim. I love it. Smart decision and positive action. That's what the ham fraternity is all about. 73 Bob, K4TAX _______________________________________________ TenTec mailing list TenTec@contes
/archives//html/TenTec/2003-10/msg00181.html (9,282 bytes)

367. Re: Orion was ( [TenTec] Hercules III / Mark Erbaugh) (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Tue, 07 Oct 2003 08:28:20 -0500
I see it this way. Does one want a high performance radio or a high performance display? I see the Orion as a high performance radio with a very adequate mono display. The others, I see them as a hig
/archives//html/TenTec/2003-10/msg00210.html (10,809 bytes)

368. Re: Orion was ( [TenTec] Hercules III / Mark Erbaugh) (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Tue, 07 Oct 2003 20:54:58 -0500
Oh yes one can have both. It just takes dollars. I truly think that Tentec designed a high end radio and in doing so had a target price of $3300. To add more features, color display and etc will cost
/archives//html/TenTec/2003-10/msg00246.html (11,465 bytes)

369. Re: Orion was ( [TenTec] Hercules III / Mark Erbaugh) (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Tue, 07 Oct 2003 20:47:45 -0500
Simple. The "others" with the color display are in the $3K class. To me that says they have a $2000 radio and a $1000 display with the stuff to drive it. The Orion is a $3300 radio and if one adds a
/archives//html/TenTec/2003-10/msg00247.html (15,509 bytes)

370. Re: [TenTec] Orion's lack of color (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Tue, 07 Oct 2003 21:08:01 -0500
Duh, it is a marketing thing. Color TV was the new whiz bang replacing B & W TV. Just like digital TV is the latest whiz bang which will replace the NTSC color system. Just like stereo took over from
/archives//html/TenTec/2003-10/msg00248.html (9,465 bytes)

371. Re: [TenTec] psk31 with orion (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Wed, 08 Oct 2003 16:27:32 -0500
Use the Tentec 705 desk mikes as it is always off unless the PTT button is pressed or the PTT lock is pressed on the mike. Therefore, there is no concern with room noise getting into the audio. The V
/archives//html/TenTec/2003-10/msg00266.html (8,641 bytes)

372. Re: Orion was ( [TenTec] Hercules III / Mark Erbaugh) (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Wed, 08 Oct 2003 17:01:51 -0500
I do weak signal work on 144 MHz and 432 MHz. Therefore, I avoid contests like the plague. Big difference in our operating requirements and thus the electronics required. 73 Bob, K4TAX ______________
/archives//html/TenTec/2003-10/msg00267.html (13,730 bytes)

373. Re: [TenTec] Timewave 59+ with Omni 6+ (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Thu, 09 Oct 2003 16:24:51 -0500
I have a Timewave DSP 9+. It works great but not as good as the DSP in the Omni VI+. I use it on my Paragon which does not have auto null or NR functions. I suggest that you put the Tentec 1.8 KHz fi
/archives//html/TenTec/2003-10/msg00293.html (9,023 bytes)

374. Re: [TenTec] Opinions on StepIR vertical (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Fri, 10 Oct 2003 16:40:37 -0500
I tend to agree strongly with Stuart's comments, especially on the area of concern regarding holding up in the WX. I lived in S. FL for several years and found the most metals would fail sooner than
/archives//html/TenTec/2003-10/msg00314.html (11,714 bytes)

375. Re: [TenTec] Jupiter + Studio One microphone settings (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Sat, 11 Oct 2003 08:00:23 -0500
Better yet, turn off the speech processor, set the rolloff to have minimum effect or none, set the TX bandwidth to 2.4 KHz. Adjust the mike gain so that the ALC just begins to indicate ALC action. Ru
/archives//html/TenTec/2003-10/msg00338.html (10,178 bytes)

376. [TenTec] Needed Filter (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Sun, 29 Feb 2004 22:57:41 -0600
I am needing a 250 Hz filter, 6.3 MHz IF, model 282 for Paragon. Please reply OFF REFLECTOR via e-mail with price and etc. 73 Bob, K4TAX _______________________________________________ TenTec mailing
/archives//html/TenTec/2004-03/msg00000.html (6,415 bytes)

377. Re: [TenTec] Plate amperes ? (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Mon, 01 Mar 2004 11:24:51 -0600
The plate current should be kept below 0.8A which is the lower end of the "black line". Grid current should be kept below 260 ma which is the lower end of the "red line" on the meter. With the transc
/archives//html/TenTec/2004-03/msg00016.html (7,891 bytes)

378. Re: [TenTec] Please take me off the server (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Tue, 02 Mar 2004 08:00:04 -0600
Viruses are not coming in with any Tentec e-mails that I see. 73 Bob, K4TAX _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailm
/archives//html/TenTec/2004-03/msg00050.html (8,785 bytes)

379. Re: [TenTec] The Tea Party (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Thu, 04 Mar 2004 18:52:51 -0600
Here is my earlier direct response to one of the contributors here on the reflector on the BPL issue. Lets be positive about any attempt we might muster. Think about results not retaliation. Now, bac
/archives//html/TenTec/2004-03/msg00123.html (10,029 bytes)

380. Re: [TenTec] The Tea Party (score: 1)
Author: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Date: Fri, 05 Mar 2004 08:20:49 -0600
Most of the modern power companies are running typically 26 KV distribution. Older 3 phase systems run 13.2 to 13.6 KV distribution while some older single phase systems are still 6900 on the primary
/archives//html/TenTec/2004-03/msg00134.html (10,550 bytes)


This search system is powered by Namazu