They had three exhibit spaces...Alpha, TenTec and Dishtronics Perry w8au _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/
I picked up some of these last year. They were way off the mark on capacity. The ones I had measured above 700 pf. If your application is not dependent on an exact cap value then these may suffice.
Near the coax connector is a vertical slide switch that shifts the receiver'to a separate antenna jack. slide it up and down a few times to clean the contacts. This is not a new situation with that
The day I cannot longer do it I think I'll use WD40 and carefully lube all moving parts, wiping the excess oil with toilet paper. Doing it in a hot day will ease things, of course. Something I have d
I have a question about how to remove the existing speaker that failed (open speaker coil) The speaker periphery is cemented in somehow and seems impossible to remove. Any helpful ideas? Thanks / 73,
Many thanks to Carlos VK1EA and Mike WB8VGE for solutions. I now see the light at the end of the tunnel... :-) Tnx. Perry w8au I cut the main body (the four flat arms) with a dremel tool, leaving a
To Gary and group: My TT 9420 developed a problem of not energizing when the xcvr (Paragon) was turned on. Problem was the 15 Volt "keep alive" circuit had failed. The small transformer feeding this
Winston. Interested in the rx10 .advise if still available thank you. Perry. W8AUSent from my Verizon, Samsung Galaxy smartphone -- Original message --From: Winston <jones_winston@bellsouth.net> D
Josh's idea of feeding 12V into the rear 12 Accessory socket works well but there is no overcurrent protection or meter reading. I did this years ago when running the C21 mobile. I turned the drive
Ken: is the digital readout compatible with the Omni C? If so, what are you asking? 73, Perry _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.c
Ken: How much for the C-21 filter cap? Perry, w8au _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Shawn: It might be easier to strip the covering off and repaint the top and bottom covers in Black wrinkle finish paint. I discovered that auto parts stores carry a black wrinkle for engines that wor