I just hooked my new TigerTronics SignaLink USB box between my Linux (Kubuntu 11.04, Natty) computer and my Orion II, after properly installing the four jumper wires in the SignaLink. I fired up Fldi
Folks, I am trying to remove the main tuning knob from the Corsair II. Someone told me the set screw took a 1/16 inch hex wrench (AKA allen). However, I have been unable to get the 1/16 inch Allen wr
Jerry, It always helped me to say bad things. Actually, I just checked the allen wrenches I used for that (don't have a Corsair II any more) and they are all 5/64 and smaller. And, the right one can
John, here is a good tutorial with pictures, etc: http://myplace.frontier.com/~nb6z/start.htm Gud Luk! Rick, DJ0IP I hope someone can direct me to a beginner's tutorial on this topic somewhere. I jus
I have a triton IV which has always worked very well but now has low transmit power on 10 meters. All the other bands work fine with full rf output. Any help will be appreciated. Buff WB2SIH
Author: "J. W. (Dub) Thornton" <dub@atlinkwifi.com>
Date: Fri, 21 Oct 2011 06:21:32 -0500
Jerry: 1/16" allen wrench is too large for the screw. Metric 1.3mm, or American .050" will do the trick, however, be sure you get a good quality allen wrench. The cheap import stuff, such as Harbor F
I used to have a small box full of Allen wrenches with sizes from 1.2mm to 1.7mm in 0.1mm steps !!!! No longer - the one which fits the Corsair tuning knob is now in its own box with a big label atta
Thanks to Dub Thornton and Andrew Moore, I was able to finally remove the tuning knob from my Corsair II without resorting to using bad words! I was trying to use a 1/16 inch hex wrench but Dub and A
Jerry, "Am I now in the exclusive club? ;-) " Not until you've drilled out the set-screw hole and re-tapped it for something bigger. And not until you can replace the dial skirt without using bad wor
I think I'll pass on the exclusive club! Does the dial skirt just slip/slide off? Jerry W5JH Jerry, "Am I now in the exclusive club? ;-) " Not until you've drilled out the set-screw hole and re-tappe
I think to be a member of the Ten Tec Totally Twisted Club, you have to rebuild the PTO and drop the little locking pin into the carpet, find it and drop it again, find it once more, install it and p
My 2003 vintage Orions both had black batteries, not the yellow battery shown in the picture detailing the version 2 software update. The new ones from TenTec are yellow, and are the same part number
John, Have you reversed the mark and space tones by any chance? RTTY requires that the mark and space frequencies have the proper relationship or all you get is gibberish. I think I recall that you a
Glenn, I am going to try my best to skip that club. ;-) Jerry W5JH I think to be a member of the Ten Tec Totally Twisted Club, you have to rebuild the PTO and drop the little locking pin into the car
I've got an Inrad #353 250hz roofing filter for the Orion II/Eagle and would like to work out a trade +/- cash for a Ten-Tec #2002 300hz roofing filter. Please email me directly if interested. The In