Have a LK 800 with a problem After it has goes through the 3 minute warm up
period, it then clicks over for about 5 seconds to it's correct mode, and
then goes to transmit mode, drawing about 50 mils on the plate. I can't key
the linear or get it to go to the receive mode.
Also, the cabinet was measured with about 60 volts on it. This unit has
the separate power source, using a 110 and 220 plug setup that Omega ,
K4BWC, has set up the last time this puppy blew up.
Maui is a long way from Omega. Before I ship it off, anybody got any
ideas?
Aloha, Al
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|