Amps
[Top] [All Lists]

[AMPS] Emission from Thoria Filaments

To: <amps@contesting.com>
Subject: [AMPS] Emission from Thoria Filaments
From: KF0FX@aol.com (KF0FX)
Date: Thu, 30 Apr 1998 08:25:35 EDT
In a message dated 4/30/98 2:16:52 AM Central Daylight Time, measures@vc.net
writes:

<< -  - How does one determine how much tungsten carbide has been formed?: 
  .  Tungsten is a better electrical conductor than tungsten-carbide, so 
 one can tell how thick the tungsten-carbide layer is by measuring the 
 decrease in filament current as the process takes place. >>

Ya, but if the tungsten-carbide layer is at the surface, it's cross-sectional
area must be quite small compared to the entire filament.  I would think
that's a difficult measurement to make.  Admittedly, Eimac's explanation was a
little high level.  Who knows?  I do know that the thorium tends to make the
filament less brittle and easier to handle.

BTW Rich, do you still have that Web site with your manuscripts regarding
amplifiers?  I have a couple of friends here who would like copies of some of
the articles you wrote.

Thanks,
Chris, KF0FX
KF0FX@aol.com

--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>