I have a kilovac H-1A relay which appears to have lost its seal - the
glass has cracked round one pin and the plating on the actuator has gone
corroded and pitted. I was aiming to use it for its current capability
rather than needing the high voltage capability (cold switching). Will
this be affected by gassing? What are the contacts made from?
Thanks, Steve
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|